What Are The Specific Steps in The COB Packaging Process?

Aug 02, 2025

Leave a message

Step 1: Die expansion. Use an expander to evenly expand the LED wafer film, separating the tightly packed LED dies for easier die bonding.

Step 2: Adhesive bonding. Place the expanded ring on the adhesive bonding machine and apply an appropriate amount of silver paste. This step is suitable for bulk LED chips.

Step 3: Die piercing. Place the expanded ring, prepped with silver paste, into a piercing rack. Using a microscope, the operator precisely pierces the LED die onto the PCB using a piercing pen.

Step 4: Place the pierced PCB into a heat cycle oven and maintain a constant temperature until the silver paste is fully cured. The piercing time should be short to prevent oxidation of the LED chip coating due to excessive heating, which would complicate the subsequent bonding process.

Step 5: Chip bonding. Use a dispenser to apply an appropriate amount of red glue (or black glue) to the IC location on the PCB. Then, use anti-static equipment (such as a vacuum pen or needle) to accurately place the bare IC die onto the glue. Step 6: Drying. Place the PCB with the die attached back into the heat circulation oven and place it on a large flat heating plate for a constant temperature. Alternatively, choose natural curing (which takes a longer time).
Step 7: Bonding (Wire Bonding). Using an aluminum wire bonder, bridge the die (whether LED or IC) to the corresponding pads on the PCB using aluminum wire, completing the inner leads of the COB.
Step 8: Pre-testing. Use specialized testing tools (depending on the COB's application, simple equipment such as a high-precision voltage-regulated power supply) to inspect the COB board and screen out unqualified boards for rework.
Step 9: Glue Dispensing. Use a dispenser to apply an appropriate amount of prepared AB glue to the bonded LED die. For ICs, use black glue for encapsulation. Finally, perform the exterior encapsulation according to customer requirements.
Step 10: Curing. The glue-dispensed PCB is then placed back into the thermal cycle oven for a constant temperature and drying time, set to varying lengths according to specific requirements.
Step 11: Post-Testing. Using testing tools designed specifically for PCBs, the packaged PCB undergoes a comprehensive electrical performance test to accurately assess its quality.